The Reverb effect adds ambience and warmth to an audio clip by simulating the sound of the audio playing in a room. Use the graphical controls in the Custom Setup view, or adjust values in the Individual Parameters view. This effect is available for 5.1, stereo, or mono clips.

Pre Delay

Specifies the time between the signal and the reverberation. This setting correlates to the distance a sound travels to the reflecting walls and back to the listener in a live setting.

Absorption

Specifies the percentage in which the sound is absorbed.

Size

Specifies the size of the room as a percentage.

Density

Specifies the density of the reverb “tail.” The Size value determines the range in which you can set Density.

Lo Damp

Specifies the amount of dampening for low frequencies (in decibels). Dampening lower frequencies prevents the reverb from rumbling or sounding muddy.

Hi Damp

Specifies the amount of dampening of high frequencies (in decibels). Low settings make the reverb sound softer.

Mix

Controls the amount of reverb.